DSD Information System
Home >> Toyota >> 2021 >> Highlander LE, 4WD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 40 (Hybrid Battery Control System - Service Information (2 Of 2)) >> Sub Radiator >> Removal [12/2019 - 10/2022] >> Caution / Notice / Hint

Caution / Notice / Hint

WARNING: This page is about a different variant/trim than selected.

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during radiator assembly removal/installation are shown below.

NECESSARY PROCEDURES AFTER PARTS REMOVED/INSTALLED/REPLACED

Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Front bumper assembly* w/ Panoramic View Monitor System: 
  1. Front television camera view adjustment
 Panoramic View Monitor System Refer to CALIBRATION [12/2019 - 10/2022]
Replacement or removal and installation of 2 or more parts: 
  • Front television camera assembly*, radiator grille sub-assembly* or front bumper assembly*
  • Rear television camera assembly*
  • Side television camera assembly LH* or outer rear view mirror assembly LH*
  • Side television camera assembly RH* or outer rear view mirror assembly RH*
 w/ Panoramic View Monitor System: 
  1. Television camera view adjustment
 Panoramic View Monitor System Refer to CALIBRATION [12/2019 - 10/2022]
  • Headlight ECU sub-assembly LH
  • Headlight assembly LH
  • Synchronize the vehicle information
  • Perform headlight ECU sub-assembly LH initialization
 Lighting System (EXT) (w/ AFS) Refer to INITIALIZATION [12/2019 - 11/2023]

*: Even when not replacing the part, it is necessary to perform the specified necessary procedures after installation.

Diesel-Data.com