DSD Information System
Home >> Toyota >> 2021 >> Highlander LE, 4WD >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Electronically Controlled Brake System (Except HV) - Diagnostics - Introduction (1 Of 2) >> ELECTRONICALLY CONTROLLED BRAKE SYSTEM (for Gasoline Model) >> DTC Check / Clear [12/2019 - ] >> DTC Check / Clear [12/2019 - ]

DTC Check / Clear [12/2019 - ]

  1. DTC CHECK 
    1. Turn the ignition switch off.
    2. Connect the GTS to the DLC3.
    3. Turn the ignition switch to ON.
    4. Turn the GTS on.
    5. Read the DTCs following the prompts on the GTS. Enter the following menus: Chassis / Brake/EPB / Trouble Codes.

      Chassis > Brake/EPB > Trouble Codes 

    6. Check the details of the DTCs.
      NOTE:
      • Make sure to clear the DTCs after repair.
      • The vehicle stability control system outputs DTCs for the following system. When DTCs other than those in Diagnostic Trouble Code Chart for the vehicle stability control system are output, refer to Diagnostic Trouble Code Chart for the relevant system.
        System Proceed to
        Electric Parking Brake System Refer to DIAGNOSTIC TROUBLE CODE CHART [12/2019 - 11/2023] , or refer to DIAGNOSTIC TROUBLE CODE CHART [11/2023 - ]

      HINT: 

      Display Item Description
      Test Failed Shows the malfunction judgment results during the current trip.
      Confirmed Shows the DTCs confirmed up to now (The number of current trips differs for each DTC.)
    7. Check the Freeze Frame Data.
      1. If a DTC is stored, check the corresponding Freeze Frame Data to gain an understanding of the vehicle condition at the time.

        Refer to FREEZE FRAME DATA [12/2019 - 11/2023] , or refer to FREEZE FRAME DATA [11/2023 - ] 

  2. CHECK TIME STAMP 

    HINT: 

    By checking Time Stamp, the time and order in which DTCs were stored in an ECU can be checked.

    1. Turn the ignition switch off.
    2. Connect the GTS to the DLC3.
    3. Turn the ignition switch to ON.
    4. Turn the GTS on.
    5. Enter the following menus: Health Check.
    6. Perform the following steps when the data setting screen is displayed.
    7. Select the systems for which to perform Health Check and check for time stamp data.

      Selectable items: 

      • Powertrain
      • Chassis
      • Body
      • Store All Data
    8. Select "Yes" when "Would you like to include Time Stamp Data?" is displayed.

      HINT: 

      If "Yes" is not selected, time stamp data will not be stored.

    9. After Health Check has completed, select "Time Stamp Data" to display the Time Stamp screen.
    10. Select the desired system from the drop-down list on the bottom of the Time Stamp screen.
    11. Check the order and time which DTCs were stored for the selected system.
  3. DTC CLEAR 
    1. Turn the ignition switch off.
    2. Connect the GTS to the DLC3.
    3. Turn the ignition switch to ON.
    4. Turn the GTS on.
    5. Operate the GTS to clear the codes. Enter the following menus: Chassis / Brake/EPB / Trouble Codes.

      Chassis > Brake/EPB > Clear DTCs 

    6. Clear the DTCs by following the prompts on the GTS.

      HINT: 

      Refer to the GTS operator's manual for further details.

Diesel-Data.com