DSD Information System
Home >> Toyota >> 2021 >> Highlander LE, 4WD >> Repair and Diagnosis >> Brakes >> Parking Brake System >> Electric Parking Brake System (Except HV) - Diagnostic Codes & Symptom Tests >> ELECTRIC PARKING BRAKE SYSTEM (for Gasoline Model) >> DTC C060B-11: Left Electric Parking Brake Actuator Control Circuit Short to Ground [12/2019 - ] >> Procedure

DTC C060B-11: Left Electric Parking Brake Actuator Control Circuit Short to Ground [12/2019 - ]: Procedure

  1. INSPECT NO. 2 PARKING BRAKE WIRE ASSEMBLY 
    1. Turn the ignition switch off.
    2. Make sure that there is no looseness at the locking part and the connecting part of the connectors.

      OK

      The connector is securely connected.

    3. Disconnect the uM2 and u2 No. 2 parking brake wire assembly connectors.
    4. Check both the connector case and the terminals for deformation and corrosion.

      OK

      No deformation or corrosion.

    5. Measure the resistance according to the value(s) in the table below.
      GTY909330Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Front view of No. 2 Parking Brake Wire Assembly *b (to wire harness connector)
      *c (to Parking Brake Actuator Assembly LH) - -

      Standard Resistance

      Tester Connection Condition Specified Condition
      uM2-1 or u2-2 (+) - Body ground and other terminals Always 10 kΩ or higher
      uM2-2 or u2-1 (-) - Body ground and other terminals Always 10 kΩ or higher

      Result

      Proceed to
      OK
      NG

    Result: 

    NG 

    REPLACE NO. 2 PARKING BRAKE WIRE ASSEMBLY 

    Result: 

    OK 

    See step  2

  2. CHECK HARNESS AND CONNECTOR (SKID CONTROL ECU (BRAKE ACTUATOR ASSEMBLY) - PARKING BRAKE ACTUATOR ASSEMBLY LH) 
    1. Turn the ignition switch off.
    2. Make sure the No. 2 parking brake wire assembly is securely installed.
    3. Disconnect the A39 skid control ECU (brake actuator assembly) connector.
    4. Disconnect the u2 parking brake actuator assembly LH connector.
    5. Measure the resistance according to the value(s) in the table below.

      Standard Resistance

      Tester Connection Condition Specified Condition
      A39-3 (MRL+) or u2-2 (+) - Body ground Always 10 kΩ or higher
      A39-2 (MRL-) or u2-1 (-) - Body ground Always 10 kΩ or higher

      Result

      Proceed to
      OK
      NG

    Result: 

    NG 

    REPAIR OR REPLACE HARNESS OR CONNECTOR 

    Result: 

    OK 

    See step  3

  3. INSPECT PARKING BRAKE ACTUATOR ASSEMBLY LH 
    1. Remove the parking brake actuator assembly LH.

      Refer to REMOVAL [12/2019 - ]

    2. Inspect the parking brake actuator assembly LH.

      Refer to INSPECTION [12/2019 - ]

      Result

      Proceed to
      OK
      NG

    Result: 

    OK 

    REPLACE SKID CONTROL ECU (BRAKE ACTUATOR ASSEMBLY). Refer to  REMOVAL [12/2019 - 10/2022]  , or refer to  REMOVAL [10/2022 - 11/2023]  , or refer to  REMOVAL [11/2023 - ] 

    Result: 

    NG 

    REPLACE PARKING BRAKE ACTUATOR ASSEMBLY LH. Refer to  REMOVAL [12/2019 - ]