DSD Information System
Home >> Toyota >> 2021 >> Highlander LE, 4WD >> Repair and Diagnosis >> Accessories & Equipment >> Drivers Assistance Systems - ADAS >> Parking Support Brake System - Diagnostics - Introduction >> Parking Support Brake System >> Data List / Active Test [11/2023 - ] >> Data List / Active Test [11/2023 - ]

Data List / Active Test [11/2023 - ]

  1. DATA LIST 
    NOTE:

    In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.

    HINT: 

    Using the GTS to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.

    1. Refer to Intuitive Parking Assist System.

      Refer to DATA LIST / ACTIVE TEST [11/2023 - ]

  2. ACTIVE TEST 

    HINT: 

    Using the GTS to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.

    1. Enter the following menus: Chassis / Brake/EPB / Active Test.

      Chassis > Brake/EPB > Active Test 

      Tester Display Measurement Item Control Range Diagnostic Note
      Stop Lamp Relay Stop lights ON / OFF Test possible at vehicle speed of 0 km/h (0 mph)
    2. Enter the following menus: Body Electrical / Combination Meter / Active Test.
    3. According to the display on the GTS, perform the Active Test.

      Body Electrical > Combination Meter > Active Test 

      Tester Display Measurement Item Control Range Diagnostic Note
      ICS OFF Warning Combination meter assembly ON / OFF -
    4. Enter the following menus: Body Electrical /Clearance Warning / Active Test.
    5. According to the display on the GTS, perform the Active Test.

      Body Electrical > Clearance Warning > Active Test 

      Tester Display Measurement Item Control Range Diagnostic Note
      Front Buzzer No. 1 clearance warning buzzer Stop or Operate Confirm that the vehicle is stopped and the ignition switch is ON
      Rear Buzzer No. 2 clearance warning buzzer Stop or Operate Confirm that the vehicle is stopped and the ignition switch is ON
Diesel-Data.com