Caution / Notice / Hint
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during blower unit removal/installation are shown below.
| Replaced Part or Performed Procedure | Necessary Procedure | Effect/Inoperative Function when Necessary Procedure not Performed | Link |
|---|---|---|---|
| Steering sensor* | Steering angle neutral point | Parking Support Brake System | Refer to CALIBRATION [11/2023 - ] |
*: Even when not replacing the part, it is necessary to perform the specified necessary procedures after installation.
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during switch housing removal/installation are shown below.
Be sure to read Precaution thoroughly before servicing.
Refer to PRECAUTION [11/2023 - ]
After the ignition switch is turned off, there may be a waiting time before disconnecting the negative (-) auxiliary battery terminal.
HINT:
- When the cable is disconnected / reconnected to the auxiliary battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.LEARNING COMPLETES WHEN VEHICLE IS DRIVEN
Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link Stop and Start System Idle the engine for approximately 5 to 60 minutes or drive the vehicle until stop and start control is permitted. Refer to PRECAUTION [11/2023 - ] Lane Control System Perform steering sensor zero point calibration Refer to INITIALIZATION [12/2019 - ] Pre-collision System Lighting System (EXT) (w/ AFS) LEARNING COMPLETES WHEN VEHICLE IS OPERATED NORMALLYEffect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link Power Door Lock Control System Initialize back door lock Refer to INITIALIZATION [11/2023 - ] Power Back Door System Reset back door close position Refer to INITIALIZATION [11/2023 - ] Air Conditioning System After the ignition switch is turned to ON, the servo motor standard position is recognized. - - Before removing the blower assembly, set the air conditioning to recirculation mode.