Odo/Trip Switch Malfunction [12/2019 - ]: Procedure

1. Read the Data List according to the display on the GTS.

   Body Electrical > Combination Meter > Data List 

   Tester Display	Measurement Item	Range	Normal Condition	Diagnostic Note
   ODO/TRIP Change Switch	ODO/TRIP switch	OFF or ON	OFF: Switch released ON: Switch pushed	When the switch is built into the combination meter assembly or is connected via direct line, the input value is displayed.

   Body Electrical > Combination Meter > Data List 

   Tester Display
   ODO/TRIP Change Switch

   OK

   ODO/TRIP switch condition displayed on the GTS changes with the actual switch operation.

   Result

   Proceed to
   OK
   NG

Result: 

OK 

REPLACE COMBINATION METER ASSEMBLY. Refer to  REMOVAL [12/2019 - ] 

Result: 

NG 

See step  2

1. Remove the trip switch.

   Refer to REMOVAL [12/2019 - ]

2. Inspect the trip switch.

   Refer to INSPECTION [12/2019 - ]

   Result

   Proceed to
   OK
   NG

Result: 

NG 

REPLACE TRIP SWITCH. Refer to  REMOVAL [12/2019 - ] 

Result: 

OK 

See step  3

1. Disconnect the H22 combination meter assembly connector.
2. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   H23-3 (A/B) - H22-1 (ODO)	Always	Below 1 Ω
   H23-1 (E) - H22-5 (SW3)	Always	Below 1 Ω
   H23-3 (A/B) or H22-1 (ODO) - Body ground	Always	10 kΩ or higher

   Result

   Proceed to
   OK
   NG

Result: 

OK 

REPLACE COMBINATION METER ASSEMBLY. Refer to  REMOVAL [12/2019 - ] 

Result: 

NG 

REPAIR OR REPLACE HARNESS OR CONNECTOR