DSD Information System
Home >> Toyota >> 2021 >> Highlander LE, 4WD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 65 (Electronically Controlled Brake System (HV) - Diagnostic Codes (10 Of 11)) >> ELECTRONICALLY CONTROLLED BRAKE SYSTEM (for HV Model) >> DTC C14E6-14: Left Rear Wheel Speed Sensor Supply Voltage Circuit Short to Ground or Open; DTC C14E9-14: Right Rear Wheel Speed Sensor Supply Voltage Circuit Short to Ground or Open [10/2021 - 11/2023] >> Typical Enabling Conditions

Typical Enabling Conditions

WARNING: This page is about a different variant/trim than selected.
C14E7 (CASE 1)

Monitor runs whenever the following DTCs are not stored C050D (Case 4): Wheel speed sensor (RL) range/performance
C050E: Wheel speed sensor (RL) voltage circuit open
C050F: Wheel speed sensor (RL) voltage circuit high
C1241: Brake system voltage input out of range low
C137D: Brake system voltage input out of range high
All of the following conditions are met -
+BS voltage 9.5 V or more, and 17.4 V or less
Command to wheel speed sensor power supply On
Wheel speed sensor current Less than 0.034 A
IG1 On
C14E7 (CASE 2)

Monitor runs whenever the following DTCs are not stored C050D (Case 4): Wheel speed sensor (RL) range/performance
C050E: Wheel speed sensor (RL) voltage circuit open
C050F: Wheel speed sensor (RL) voltage circuit high
C137D: Brake system voltage input out of range high
All of the following conditions are met -
+BS voltage 9.5 V or more, and 17.4 V or less
Command to wheel speed sensor power supply On
Wheel speed sensor current Less than 0.034 A
C14EA (CASE 1)

Monitor runs whenever the following DTCs are not stored C0513 (Case 4): Wheel speed sensor (RR) range/performance
C0514: Wheel speed sensor (RR) voltage circuit open
C0515: Wheel speed sensor (RR) voltage circuit high
C1241: Brake system voltage input out of range low
C137D: Brake system voltage input out of range high
All of the following conditions are met -
+BS voltage 9.5 V or more, and 17.4 V or less
Command to wheel speed sensor power supply On
Wheel speed sensor current Less than 0.034 A
IG1 On
C14EA (CASE 2)

Monitor runs whenever the following DTCs are not stored C0513 (Case 4): Wheel speed sensor (RR) range/performance
C0514: Wheel speed sensor (RR) voltage circuit open
C0515: Wheel speed sensor (RR) voltage circuit high
C137D: Brake system voltage input out of range high
All of the following conditions are met -
+BS voltage 9.5 V or more, and 17.4 V or less
Command to wheel speed sensor power supply On
Wheel speed sensor current Less than 0.034 A
Diesel-Data.com