DSD Information System
Home >> Toyota >> 2021 >> Highlander LE, 4WD >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Drivers Assistance Systems - ADAS >> Monitor System - Service Information >> Blind Spot Monitor Sensor >> Installation [11/2023 - ] >> Procedure

Installation [11/2023 - ]: Procedure

  1. INSTALL BLIND SPOT MONITOR SENSOR LH 
    1. Connect the connector.
    2. Install the blind spot monitor sensor LH with the 3 nuts.

      Torque: 10 N.m (102 kgf/cm, 7 ft.lbf) 

  2. INSTALL BLIND SPOT MONITOR SENSOR RH 
    1. Connect the connector.
    2. Install the blind spot monitor sensor RH with the 3 nuts.

      Torque: 10 N.m (102 kgf/cm, 7 ft.lbf) 

  3. PERFORM BLIND SPOT MONITOR SENSOR INSTALLATION CONDITION INSPECTION 

    See step  4

  4. INSTALL REAR BUMPER ASSEMBLY 

    Refer to INSTALLATION [10/2022 - ]

  5. BSM ECU DATA WRITE 
    NOTE:

    BSM ECU data write can only be performed when the beam axis adjustment value is able to be saved to the GTS.

    See step  2

  6. PERFORM BLIND SPOT MONITOR BEAM AXIS CONFIRMATION 

    See step  3

  7. PERFORM DIAGNOSTIC SYSTEM CHECK 

    Refer to DTC CHECK / CLEAR [11/2023 - ]

Diesel-Data.com