DSD Information System
Home >> Toyota >> 2021 >> Highlander LE, 4WD >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Drivers Assistance Systems - ADAS >> Monitor System - Service Information >> Panoramic View Monitor Switch >> Inspection [12/2019 - ] >> Procedure

Inspection [12/2019 - ]: Procedure

  1. INSPECT PANORAMIC VIEW MONITOR SWITCH (FRONT WIDE VIEW SWITCH) 
    1. Remove the panoramic view monitor switch (front wide view switch).

      Refer to REMOVAL [12/2019 - ] 

    2. Measure the resistance according to the value(s) in the table below.
      GTY921301Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Component without harness connected
      (Panoramic View Monitor Switch (Front Wide View Switch))

      Standard Resistance

      Tester Connection Switch Condition Specified Condition
      5 (D) - 2 (E) Panoramic view monitor switch (front wide view switch) pushed Below 1 Ω
      Panoramic view monitor switch (front wide view switch) not pushed 10 kΩ or higher

      If the result is not as specified, replace the panoramic view monitor switch (front wide view switch).

    3. Check that the switch illumination illuminates.
      1. Apply auxiliary battery voltage to the panoramic view monitor switch (front wide view switch) and check that the switch illumination illuminates.

        OK

        Connection Specified Condition
        Auxiliary battery positive (+) → Terminal 6 (ILL+)
        Auxiliary battery negative (-) → Terminal 1 (ILL-)        		 Illuminates

        If the result is not as specified, replace the panoramic view monitor switch (front wide view switch).

        GTY921300Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
        *a Component without harness connected
        (Panoramic View Monitor Switch (Front Wide View Switch))
    4. Install the panoramic view monitor switch (front wide view switch).

      Refer to INSTALLATION [12/2019 - ] 

Diesel-Data.com