Typical Malfunction Thresholds
WARNING: This page is about a different variant/trim than selected.
C12D3 (CASE 1)
| Solenoid load open/short to ground signal | On |
C12D3 (CASE 2)
| Either of the following conditions is met | - |
| Solenoid return current terminal disconnection signal | On |
| Solenoid GND terminal disconnection signal | On |
C12D3 (CASE 3)
| Divide ABS hold solenoid current monitor value by ABS hold solenoid target current value | Less than 0.25 |
C12D4 (CASE 1)
| ABS hold solenoid current monitor value | Higher than 0.1 A |
C12D4 (CASE 2)
| Either of the following conditions is met | - |
| Solenoid overcurrent signal | On |
| Solenoid driver overtemperature signal | On |
C12D4 (CASE 3)
| Solenoid load leakage signal | On |
C12D4 (CASE 4)
| Either of the following conditions is met | A or B |
| A. Both of the following conditions are met | - |
| Divide ABS hold solenoid current monitor value by ABS hold solenoid target current value | Higher than 2 |
| ABS hold solenoid target current value | 0.25 A or more |
| B. Both of the following conditions are met | - |
| ABS hold solenoid current monitor value | Higher than 0.5 A |
| ABS hold solenoid target current value | Less than 0.25 A |
C12DE (CASE 1)
| Solenoid load open/short to ground signal | On |
C12DE (CASE 2)
| Either of the following conditions is met | - |
| Solenoid GND terminal disconnection signal | On |
| Solenoid load open at on signal | On |
C12DF (CASE 1)
| Either of the following conditions is met | - |
| Solenoid overcurrent signal | On |
| Solenoid driver overtemperature signal | On |
C12DF (CASE 2)
| Solenoid load leakage signal | On |