DTC C1625: Open or Short in Steering Angle Sensor +B [12/2019 - 10/2022]: Procedure

1. Disconnect the H57 steering sensor connector.

   Refer to REMOVAL [12/2019 - 10/2022]

2. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   H57-6 (ESS) - Body ground	Always	Below 1 Ω

3. Measure the voltage according to the value(s) in the table below.

   Standard Voltage

   Tester Connection	Condition	Specified Condition
   H57-9 (IG1) - H57-6 (ESS)	Ignition switch ON	11 to 14 V*1,*3
   		10.5 to 16 V*2
   H57-4 (BAT) - H57-6 (ESS)	Ignition switch off*1	11 to 14 V
   	Always*2,*3

   1. *1: for HV Model
   2. *2: for Gasoline Model with Stop and Start System
   3. *3: for Gasoline Model without Stop and Start System

   Result

   Result	Proceed to
   OK	A
   NG (for HV Model, for Gasoline Model without Stop and Start System)	B
   NG (w/ Stop and Start System)	C

Result: 

A 

REPLACE STEERING SENSOR. Refer to  REMOVAL [12/2019 - 10/2022] 

Result: 

B 

REPAIR OR REPLACE HARNESS OR CONNECTOR 

Result: 

C 

GO TO STOP AND START SYSTEM. Refer to  HOW TO PROCEED WITH TROUBLESHOOTING [12/2019 - 10/2022]