Typical Enabling Conditions
WARNING: This page is about a different variant/trim than selected.
| Monitor runs whenever the following DTCs are not stored | C1021 (Case 1): Brake system voltage input out of range low C137D: Brake system voltage input out of range high |
| All of the following conditions are met | - |
| Command to all ABS hold solenoids | Off |
| Command to all ABS release solenoids | Off |
| IGR voltage | 3.5 V or more |
| +BS voltage | 17.4 V or less |
| Chassis dynamometer mode | Off |
| The lowest speed sensor output value | Higher than 20 km/h (12.43 mph) |