DSD Information System
Home >> Toyota >> 2021 >> Highlander LE, 4WD >> Repair and Diagnosis >> General Information >> OEM General Information >> Setup >> When Disconnecting Or Reconnecting Battery Terminal >> Automatic Learning Chart [11/2023 - ] >> Automatic Learning Chart [11/2023 - ]

Automatic Learning Chart [11/2023 - ]

  1. AUTOMATIC LEARNING PERFORMED WHEN CABLE IS DISCONNECTED / RECONNECTED TO AUXILIARY BATTERY TERMINAL 

    When the cable is disconnected / reconnected to the auxiliary battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.

    LEARNING COMPLETES WHEN VEHICLE IS DRIVEN

    Effect/Inoperative Function when Necessary Procedure not Performed Necessary Procedure Link
    Stop and Start System Idle the engine for approximately 5 to 60 minutes or drive the vehicle until stop and start control is permitted Refer to PRECAUTION [11/2023 - ]
    Lane Control System Perform steering sensor zero point calibration Refer to INITIALIZATION [12/2019 - ]
    Pre-collision System
    Lighting System (EXT) (w/ AFS)
    LEARNING COMPLETES WHEN VEHICLE IS OPERATED NORMALLY

    Effect/Inoperative Function when Necessary Procedure not Performed Necessary Procedure Link
    Power Door Lock Control System Initialize back door lock Refer to INITIALIZATION [11/2023 - ]
    Power Back Door System Reset back door close position Refer to INITIALIZATION [11/2023 - ]
    Air Conditioning System After the ignition switch is turned to ON, the servo motor standard position is recognized. -
Diesel-Data.com