DSD Information System
Home >> Toyota >> 2021 >> Highlander LE, 4WD >> Repair and Diagnosis >> Accessories & Equipment >> Headlights >> Lighting System (Ext) - Service Information >> Height Control Sensor >> Inspection [12/2019 - ] >> Procedure

Inspection [12/2019 - ]: Procedure

  1. INSPECT REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY LH 
    1. Connect 3 dry cell batteries (1.5 V) in series.
      NOTE:

      Do not use rechargeable batteries as they may not output a voltage of 1.5 V.

      GTY911057Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Component without harness connected
      (Rear Height Control Sensor Sub-assembly LH)      		 *b Low
      *c Standard Position *d High
      *e -22.4° *f +21.1°
    2. Connect a positive (+) lead from the batteries to terminal 3 (SHB) and a negative (-) lead to terminal 1 (SHG).
    3. Measure the voltage between terminals 2 (SHRR) and 1 (SHG) while slowly moving the link up and down.

      Standard Voltage

      Tester Connection Condition Specified Condition
      2 (SHRR) - 1 (SHG) +45° (High) 4.5 V
      2 (SHRR) - 1 (SHG) 0° (Standard position) 2.25 V
      2 (SHRR) - 1 (SHG) -45° (Low) 0.5 V

      If the result is not as specified, replace the rear height control sensor sub-assembly LH.

Diesel-Data.com