Inspection [10/2022 - ]: Procedure

INSPECT REAR DRIVE SHAFT ASSEMBLY

Check that there is no excessive play in the radial direction of the outboard joint.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Check that the inboard joint slides smoothly in the thrust direction.
Check that there is no excessive play in the radial direction of the inboard joint.
Check the boots for damage.

Check whether each drive shaft dimension (A) is within specification.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

NOTE:

Keep the drive shaft assembly level during inspection.

Dimension (A)

for Dynamic Torque Vectoring AWD	for LH Side	643.6 mm (2.11 ft.)
for Dynamic Torque Vectoring AWD	for RH Side	628.6 mm (2.06 ft.)
for Dynamic Torque Control AWD	for LH Side	683.25 mm (2.24 ft.)
for Dynamic Torque Control AWD	for RH Side	703.25 mm (2.31 ft.)