DSD Information System
Home >> Toyota >> 2021 >> Highlander LE, 4WD >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Drivers Assistance Systems - ADAS >> Parking Assist Monitor System - Diagnostic Codes & Symptom Tests >> Parking Assist Monitor System >> Image from Camera for Parking Assist Monitor is Abnormal [11/2023 - ] >> Procedure

Image from Camera for Parking Assist Monitor is Abnormal [11/2023 - ]: Procedure

  1. CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER ASSEMBLY - REAR TELEVISION CAMERA ASSEMBLY) 
    1. Disconnect the H129 radio and display receiver assembly connector.
    2. Disconnect the W32 rear television camera assembly connector.
    3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance

      Tester Connection Condition Specified Condition
      H129-2 (GB+) - W32-4 (CB+) Always Below 1 Ω
      H129-4 (GVO+) - W32-6 (CV+) Always Below 1 Ω
      H129-1 (GGND) - W32-3 (CGND) Always Below 1 Ω
      H129-3 (GVO-) - W32-5 (CV-) Always Below 1 Ω
      H129-2 (GB+), W32-4 (CB+) - Body ground Always 10 kΩ or higher
      H129-4 (GVO+), W32-6 (CV+) - Body ground Always 10 kΩ or higher
      H129-1 (GGND), W32-3 (CGND) - Body ground Always 10 kΩ or higher
      H129-3 (GVO-), W32-5 (CV-) - Body ground Always 10 kΩ or higher

      Result

      Proceed to
      OK
      NG

    Result: 

    NG 

    REPAIR OR REPLACE HARNESS OR CONNECTOR 

    Result: 

    OK 

    See step  2

  2. CHECK RADIO AND DISPLAY RECEIVER ASSEMBLY 
    1. Disconnect the W32 rear television camera assembly connector.
    2. Measure the resistance according to the value(s) in the table below.

      Standard Resistance

      Tester Connection Condition Specified Condition
      W32-5 (CV-) - Body ground Always Below 1 Ω
      W32-3 (CGND) - Body ground Always Below 1 Ω
    3. Measure the voltage according to the value(s) in the table below.

      Standard Voltage

      Tester Connection Switch Condition Specified Condition
      W32-4 (CB+) - Body ground Ignition switch ACC 6 to 9 V
      Ignition switch off Below 1 V

      Result

      Proceed to
      OK
      NG

    Result: 

    NG 

    REPLACE RADIO AND DISPLAY RECEIVER ASSEMBLY. Refer to  REMOVAL [11/2023 - ] 

    Result: 

    OK 

    See step  3

  3. CHECK REAR TELEVISION CAMERA ASSEMBLY 
    1. Replace the rear television camera assembly with a new or known good one.

      Refer to REMOVAL [11/2023 - ]

    2. Check if the same malfunction reoccurs when the rear view monitor screen is displayed.

      OK

      Malfunction does not reoccur (returns to normal).

      Result

      Proceed to
      OK
      NG

    Result: 

    OK 

    END (REAR TELEVISION CAMERA ASSEMBLY WAS DEFECTIVE) 

    Result: 

    NG 

    REPLACE RADIO AND DISPLAY RECEIVER ASSEMBLY. Refer to  REMOVAL [11/2023 - ]