DSD Information System
Home >> Toyota >> 2021 >> Highlander LE, 4WD >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Drivers Assistance Systems - ADAS >> Parking Assist Monitor System - Diagnostics - Introduction >> Parking Assist Monitor System >> Terminals Of Ecu [10/2022 - 11/2023] >> Terminals Of Ecu [10/2022 - 11/2023]

Terminals Of Ecu [10/2022 - 11/2023]

  1. REAR TELEVISION CAMERA ASSEMBLY 
    Fig 1: Rear Television Camera Assembly [10/2022 - 11/2023]
    GTY1121535Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    1. Disconnect the rear television camera assembly connector.
    2. Measure the voltage on the wire harness side connector according to the value(s) in the table below.
      Terminal No. (Symbol) Terminal Description Condition Specified Condition
      W32-6 (CB+) - W32-5 (CGND) Power source Ignition switch ACC 6 to 9 V
    3. Measure the resistance on the wire harness side connector according to the value(s) in the table below.
      Terminal No. (Symbol) Terminal Description Condition Specified Condition
      W32-1 (CANH) CAN communication line - -
      W32-4 (CANL) CAN communication line - -
      W32-5 (CGND) - Body ground Camera ground Always Below 1 Ω
      W32-2 (CV-) Video signal - -
      W32-3 (CV+) Video signal - -
      W32-7 (SGND) - Body ground Camera ground (shield) Always Below 1 Ω
  2. RADIO AND DISPLAY RECEIVER ASSEMBLY 

    Refer to TERMINALS OF ECU [10/2022 - ]

Diesel-Data.com