On-Vehicle Inspection [12/2019 - ]: Procedure
- INSPECT RADIO SETTING CONDENSER
- With the radio setting condenser installed, check that there is no looseness or other abnormalities.
- Measure the resistance of the radio setting condenser according to the value(s) in the table below.
*a Radio Setting Condenser Standard Resistance
Tester Connection Condition Specified Condition 1 - Body ground - Ignition switch off
- Window Defogger turned off
- High mounted stop light off
Below 1 Ω - Remove the bolt.
- Disengage the clamp and disconnect the radio setting condenser with wire harness from the vehicle body.
- Measure the resistance and voltage of the radio setting condenser according to the value(s) in the table below.
*a Radio Setting Condenser Standard Resistance
Tester Connection Condition Specified Condition 1 - 2 - Ignition switch off
- Window Defogger turned off
- High mounted stop light off
10 kΩ or higher 1 - 3 10 kΩ or higher Standard Voltage
Tester Connection Condition Specified Condition 2 - Body ground - Ignition switch ON
- High mounted stop light off
Below 1 V 3 - Body ground - Ignition switch ON
- Window Defogger turned off
Below 1 V 2 - Body ground - Ignition switch ON
- High mounted stop light on
11 to 14 V 3 - Body ground - Ignition switch ON
- Window Defogger turned on
11 to 14 V
