DSD Information System
Home >> Toyota >> 2021 >> Highlander LE, 4WD >> Repair and Diagnosis >> Maintenance >> Procedures >> Maintenance Reminder Light (Reset Procedures) >> Tire Pressure Monitor System Reminder >> TPMS Reminder Reset - Procedure 18 >> Registration

TPMS Reminder Reset - Procedure 18: Registration

NOTE: Perform registration after replacement of the tire pressure warning ECU and receiver, or after replacement of a tire pressure sensor.
NOTE: Perform initialization only after the transmitter ID registration is completed.
NOTE:
  1. In case of tire pressure warning ECU and receiver replacement:
    • Read the registered transmitter IDs that are stored in the old ECU using the Techstream and write them down.
    • If reading the stored transmitter IDs is impossible due to malfunctions of components such as the tire pressure warning ECU and receiver, remove the tires from the wheels and check the IDs located on the tire pressure warning valve and transmitters.
  2. In case of tire pressure warning valve and transmitter replacement:
    • Take a note of the 7-digit number (transmitter ID) written on the tire pressure warning valve and transmitter.
  1. Set the tire pressure to the specified value.
  2. Turn the power switch OFF.
  3. Connect the Techstream to the DLC3.
  4. Turn the power switch ON and turn the Techstream ON.
  5. Enter the following menus: Chassis / Tire Pressure Monitor / Utility / ID Registration.
  6. Perform the procedure displayed on the Techstream.
Diesel-Data.com