How To Proceed With Troubleshooting [11/2023 - ]: Procedure

Result

Result: 

NEXT 

See step  2

1. Interview the customer to confirm the problem.

   Refer to HOW TO PROCEED WITH TROUBLESHOOTING [12/2019 - ]

   Result

   Proceed to
   NEXT

Result: 

NEXT 

See step  3

1. Measure the auxiliary battery voltage with the ignition switch off.

   Standard Voltage

   11 to 14 V

   If the voltage is below 11 V, recharge or replace the auxiliary battery before proceeding to the next step.

2. Check the fuses and relays.
3. Check the connector connections and terminals to make sure that there are no abnormalities such as loose connections, deformation, etc.

   Result

   Proceed to
   NEXT

Result: 

NEXT 

See step  4

1. Using the GTS, check for CAN communication system DTCs.

   for HV Model: Refer to DIAGNOSIS SYSTEM [11/2023 - ]

   for Gasoline Model: Refer to DIAGNOSIS SYSTEM [11/2023 - ]

   Result

   Result	Proceed to
   CAN DTCs are not output	A
   CAN DTCs are output	B

Result: 

B 

GO TO CAN COMMUNICATION SYSTEM 

for HV Model: Refer to HOW TO PROCEED WITH TROUBLESHOOTING [11/2023 - ]

for Gasoline Model: Refer to HOW TO PROCEED WITH TROUBLESHOOTING [11/2023 - ]

Result: 

A 

See step  5

1. Using the GTS, check for CXPI communication system DTCs.

   Refer to DIAGNOSTIC TROUBLE CODE CHART [11/2023 - ]

   Result

   Result	Proceed to
   CXPI DTCs are not output	A
   CXPI DTCs are output	B

Result: 

B 

GO TO CXPI COMMUNICATION SYSTEM. Refer to  HOW TO PROCEED WITH TROUBLESHOOTING [11/2023 - ] 

Result: 

A 

See step  6

1. Check the operation of the speedometer, shift indicator and brake warning light on the combination meter assembly.

   OK

   The speedometer, shift indicator and brake warning light on the combination meter assembly operate normally.

   Result

   Proceed to
   OK
   NG

Result: 

NG 

GO TO METER / GAUGE SYSTEM 

except 12.3 Inch Display: Refer to HOW TO PROCEED WITH TROUBLESHOOTING [12/2019 - ]

for 12.3 Inch Display: Refer to HOW TO PROCEED WITH TROUBLESHOOTING [10/2022 - ]

Result: 

OK 

See step  7

1. Refer to Problem Symptoms Table.

   Refer to PROBLEM SYMPTOMS TABLE [12/2019 - ] 

   Result

   Result	Proceed to
   Fault is not listed in Problem Symptoms Table	A
   Fault is listed in Problem Symptoms Table	B

Result: 

B 

See step  9

Result: 

A 

See step  8

1. Data List / Active Test

   Refer to DATA LIST / ACTIVE TEST [11/2023 - ] 

2. Terminals of ECU

   Refer to TERMINALS OF ECU [11/2023 - ] 

3. Inspection

   Result

   Proceed to
   NEXT

Result: 

NEXT 

See step  9

Result

Result: 

NEXT 

See step  10

Result

Result: 

NEXT 

END