DSD Information System
Home >> Toyota >> 2021 >> Highlander LE, 4WD >> Repair and Diagnosis >> General Information >> Maintenance Reminder Light (Reset Procedures) >> Engine Oil Replacement Reminder >> Engine Oil Replacement Reminder Reset - Procedure 10

Engine Oil Replacement Reminder Reset - Procedure 10

  1. Switch the odometer display to TRIP A while the engine is running.
  2. Set the "ENGINE START STOP" (or ignition) switch to OFF.
  3. While pressing the trip meter reset button, set the "ENGINE START STOP" (or ignition) switch to ON mode (DO NOT start the engine). Continue to press and hold the button until the odometer displays 000000, or the multi-information display indicates that the reset is complete.
    NOTE: For 2012 Tacoma models, there is a significant difference between the reset procedure in the owner's manual (used above) and the instructions given in the Toyota service information. The owner's manual is considered to be more reliable for this type procedure, but in the event that the service information is correct, it is this:
    1. Turn the ignition switch to ON.
    2. Set the ODO/TRIP indication to ODO.
    3. While pressing the reset switch, turn the ignition switch OFF and ON again.
    4. Press the reset switch for more than 5 seconds.
NOTE: If the system fails to reset, the warning light will continue flashing.
Diesel-Data.com