DTC P011B-62: Engine Coolant Temperature / Intake Air Temperature Signal Compare Failure [12/2019 - 10/2022]: Procedure

1. Read the DTCs.

   Powertrain > Engine > Trouble Codes 

   Result

   Result	Proceed to
   DTC P011B-62 is output	A
   DTC P011B-62 and other DTCs are output	B

   HINT: 

   If any DTCs other than P011B-62 are output, troubleshoot those DTCs first.

Result: 

B 

GO TO DTC CHART. Refer to  DIAGNOSTIC TROUBLE CODE CHART [12/2019 - 09/2020]  , or refer to  DIAGNOSTIC TROUBLE CODE CHART [09/2020 - 10/2021]  , or refer to  DIAGNOSTIC TROUBLE CODE CHART [10/2021 - 10/2022] 

Result: 

A 

See step  2

1. Leave the vehicle for 7 hours or more.

   HINT: 

   It is necessary to leave the vehicle for 7 hours or more to create conditions similar to the DTC detection conditions.

2. Read the value displayed on the GTS.

   Powertrain > Engine > Data List 

   Tester Display
   Intake Air Temperature

   Standard

   Difference between the intake air temperature and the actual outside air temperature is within 10°C (18°F).

   HINT: 

   • Temperature readings on the outside temperature gauge of the vehicle (if equipped) are not suitable for comparing to the intake air temperature reading. The outside temperature gauge has a significant delay built in to prevent swings in the temperature display. Use an accurate thermometer to determine the outside air temperature.
   • Perform "Inspection After Repair" after replacing the mass air flow meter sub-assembly.

     Refer to INITIALIZATION [12/2019 - 10/2022]

   Result

   Proceed to
   OK
   NG

Result: 

NG 

REPLACE MASS AIR FLOW METER SUB-ASSEMBLY. Refer to  REMOVAL [12/2019 - 10/2022] 

Result: 

OK 

See step  3

1. Read the value displayed on the GTS.

   Powertrain > Engine > Data List 

   Tester Display
   Coolant Temperature

   Standard

   The difference between the coolant temperature and the actual outside air temperature is within 10°C (18°F).

   HINT: 

   • If the result is not as specified, check that there are no heat sources such as a block heater in the engine compartment.
   • Perform "Inspection After Repair" after replacing the engine coolant temperature sensor.

     Refer to INITIALIZATION [12/2019 - 10/2022]

   Result

   Proceed to
   OK
   NG

Result: 

OK 

REPLACE ECM. Refer to  REMOVAL [12/2019 - 09/2020]  , or refer to  REMOVAL [09/2020 - 10/2022] 

Result: 

NG 

REPLACE ENGINE COOLANT TEMPERATURE SENSOR. Refer to  REMOVAL [12/2019 - 10/2022]