Neutral Position Switch Circuit [10/2022 - ]: Procedure

1. In accordance with the display on the GTS, read the Data List.

   Powertrain > Stop and Start > Data List 

   Tester Display
   Neutral Switch

   OK

   GTS Display	Condition	Normal Condition
   Neutral Switch	Shift lever in P or N	ON
   	Shift lever not in P or N	OFF

   Result

   Proceed to
   OK
   NG

Result: 

OK 

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE. Refer to  PROBLEM SYMPTOMS TABLE [12/2019 - ] 

Result: 

NG 

See step  2

Refer to INSPECTION [10/2022 - ]

Result

Result: 

NG 

REPLACE PARK/NEUTRAL POSITION SWITCH ASSEMBLY. Refer to  REMOVAL [10/2022 - 11/2023]  , or refer to  REMOVAL [11/2023 - ] 

Result: 

OK 

See step  3

1. Disconnect the engine stop and start ECU connector.
2. Disconnect the park/neutral position switch assembly connector.
3. Disconnect the ECM connector.
4. Disconnect the certification ECU (smart key ECU Assembly) connector.
5. Remove the ST relay from the No. 1 engine room relay block and No. 1 junction block assembly.
6. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   A34-21 (STA) - C52-9 (L)	Always	Below 1 Ω
   A34-17 (CLL) - C52-4 (B)	Always	Below 1 Ω
   A34-21 (STA) or C52-9 (L) - Body ground and other terminals	Always	10 kΩ or higher
   A34-17 (CLL) or C52-4 (B) - Body ground and other terminals	Always	10 kΩ or higher

   Result

   Proceed to
   OK
   NG

Result: 

OK 

REPLACE ENGINE STOP AND START ECU. Refer to  REMOVAL [10/2022 - 11/2023]  , or refer to  REMOVAL [11/2023 - ] 

Result: 

NG 

REPAIR OR REPLACE HARNESS OR CONNECTOR