On-Vehicle Inspection [12/2019 - ]: Procedure
- INSPECT VOLTAGE INVERTER ASSEMBLY (for Gasoline Model)
- Disconnect the M79 voltage inverter assembly connector.
*a Front view of wire harness connector
(to Voltage Inverter Assembly)- - - Measure the voltage according to the value(s) in the table below.
Standard
Tester Connection Input/Output Item Condition Specified Condition 1 (IG) - Body ground Input Voltage Ignition switch ON 11 to 14 V - Measure the resistance according to the value(s) in the table below.
Standard
Tester Connection Input/Output Item Condition Specified Condition 4 (GND) - Body ground - Resistance Always Below 1 Ω If the result is not as specified, repair or replace the harness or connector.
- Reconnect the M79 voltage inverter assembly connector.
*a Component with harness connected
(Voltage Inverter Assembly)- - - Measure the voltage according to the value(s) in the table below.
Standard
Tester Connection Input/Output Item Condition Specified Condition 3 (AC1) - 7 (AC2)
*1Output Voltage Inverter operating with ignition switch ON 121 to 165 V
*27 (AC2) - 3 (AC1)
*1Output Voltage Inverter operating with ignition switch ON 121 to 165 V
*2HINT:
- *1: When measuring with the tester, set the tester to the AC voltage range as the generated voltage is AC.
- *2: Since the AC voltage cannot be precisely measured with the tester, a wide range has been listed for the specified condition.
If the result is not as specified, replace the voltage inverter assembly.
- Disconnect the M79 voltage inverter assembly connector.
