DSD Information System
Home >> Toyota >> 2021 >> Highlander LE, 4WD >> Repair and Diagnosis >> Drivelines & Axles >> Axle Shafts >> Drive Shaft / Propeller Shaft - Service Information >> FRONT DRIVE SHAFT ASSEMBLY (for 2GR-FKS) >> Removal [12/2019 - 10/2022] >> Caution / Notice / Hint

Caution / Notice / Hint

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during front drive shaft assembly removal/installation are shown below.

NECESSARY PROCEDURES AFTER PARTS REMOVED/INSTALLED/REPLACED

Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Front wheel alignment adjustment
  1. Perform "Reset Memory".
  2. Perform "Calibration".
  • VSC is disabled or malfunctions
  • DTCs are output
  • Slip indicator light illuminates
  • ABS warning light illuminates
 Refer to UTILITY [12/2019 - 11/2023]
Automatic transaxle fluid ATF thermal degradation estimate reset The value of the Data List item "ATF Thermal Degradation Estimate" is not estimated correctly for UA80E: Refer to INITIALIZATION [12/2019 - 10/2022]
for UA80F: Refer to INITIALIZATION [12/2019 - 10/2022]

HINT: 

Diesel-Data.com