Installation [12/2019 - ]: Procedure

1. Install the rear skid control sensor to the rear axle carrier sub-assembly with the bolt.

   Torque: 8.5 N.m (87 kgf/cm, 75 in.lbf) 

   NOTE:

   • Keep the tip of the rear skid control sensor and installation hole free of foreign matter.
   • Firmly insert the rear skid control sensor body into the rear axle carrier sub-assembly before tightening the bolt.
   • After installing the rear skid control sensor to the rear axle carrier sub-assembly, make sure that there is no clearance between the rear skid control sensor stay and rear axle carrier sub-assembly. Also make sure that no foreign matter is stuck between the parts.
2. Connect the No. 2 parking brake wire assembly connector to the rear skid control sensor.

Refer to INSTALLATION [12/2019 - 10/2022] , or refer to INSTALLATION [10/2022 - ]

for HV Model: Refer to TEST MODE PROCEDURE [12/2019 - 11/2023] , or refer to TEST MODE PROCEDURE [11/2023 - ]

for Gasoline Model: Refer to TEST MODE PROCEDURE [12/2019 - 11/2023] , or refer to TEST MODE PROCEDURE [11/2023 - ]