Installation [12/2019 - ]: Procedure

1. Apply a 2 to 3 mm (0.0787 to 0.118 in.) bead of adhesive (3M DP-105 or equivalent) to each new roof drip side finish moulding clip.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *a	Adhesive
   *b	2 to 3 mm Bead of Adhesive

   HINT: 

   Adhesive strength (tensile strength): 13.7 MPa (140.0 kgf/cm² , 1987 psi) or more (when the temperature is 23°C (73°F).)

2. w/o Roof Rack:
   1. Install the roof drip side finish moulding clips to the positions on the roof panel shown in the illustration. Determine the locations and firmly press and install the roof drip side finish moulding clips.

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      *a

      Protruding Part

      -

      -

      Standard Measurement

      Area	Measurement	Area	Measurement
      A	5.1 to 6.1 mm (0.0201 to 0.24 in.)	B	8.6 mm (0.339 in.)
      C	7.0 to 8.0 mm (0.276 to 0.315 in.)	D	7.6 mm (0.299 in.)
      E	5.3 to 6.3 mm (0.0209 to 0.248 in.)	F	9.7 mm (0.382 in.)

3. w/ Roof Rack:
   1. Install the roof drip side finish moulding clip to the position on the roof panel shown in the illustration. Determine the location and firmly press and install the roof drip side finish moulding clip.

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      *a

      Protruding Part

      -

      -

      Standard Measurement

      Area	Measurement	Area	Measurement
      A	5.3 to 6.3 mm (0.0209 to 0.248 in.)	B	9.7 mm (0.382 in.)

4. Install the roof drip side finish moulding when 40 minutes or more have elapsed after pressing and installing the roof drip side finish moulding clip.

   HINT: 

   • Initial hardening time: 40 minutes
   • Complete hardening time: 24 hours

1. Engage the clip and install the rear roof drip side finish moulding.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

2. Remove the protective tape.

1. Position the center roof drip side finish moulding by aligning it with the matchmark on the vehicle body as shown in the illustration.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *a

   Matchmark

2. Engage the clip and install the center roof drip side finish moulding.
3. Remove the protective tape.

1. Engage the clip and install the front roof drip side finish moulding as shown in the illustration.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   Standard Measurement

   Area	Measurement
   A	6.3 mm (0.248 in.)

2. Remove the protective tape.

1. Engage the 2 claws and 2 clips to install the 2 roof drip side finish moulding joint covers as shown in the illustration.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *a	Mark
   *b	Outside of the Vehicle

2. Remove the protective tape.

1. Engage the clip and install the rear roof drip side finish moulding as shown in the illustration.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   Standard Measurement

   Area	Measurement
   A	11.0 mm (0.433 in.)

2. Remove the protective tape.

Refer to INSTALLATION [12/2019 - ]