Caution / Notice / Hint
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during front seat assembly RH removal/installation are shown below.
NECESSARY PROCEDURES AFTER PARTS REMOVED/INSTALLED/REPLACED
| Replaced Part or Performed Procedure | Necessary Procedure | Effect/Inoperative Function when Necessary Procedure not Performed | Link |
|---|---|---|---|
| Front passenger seat* | Zero point calibration (Occupant Classification System) |
|
Refer to INITIALIZATION [11/2023 - ] |
*: Even when not replacing the part, it is necessary to perform the specified necessary procedures after installation.
WARNING:
- Be sure to read Precaution thoroughly before servicing.
Refer to PRECAUTION [11/2023 - ]
- Wear protective gloves. Sharp areas on the parts may injure your hands.
NOTE:
- If the front seat airbag assembly has been deployed, replace the front seat airbag assembly, separate type front seatback spring assembly, separate type front seatback pad and separate type front seatback cover with the necessary parts in accordance with the extent of the collision damage.
- If the front seat cushion airbag assembly RH has been deployed, replace the front seat cushion airbag assembly RH, separate type front seat cushion spring assembly, separate type front seat cushion pad and separate type front seat cushion cover with the necessary parts in accordance with the extent of the collision damage.
HINT:
When the cable is disconnected / reconnected to the auxiliary battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.
- LEARNING COMPLETES WHEN VEHICLE IS DRIVEN
Effect/Inoperative Function when Necessary Procedure not Performed Necessary Procedure Link Stop and Start System Idle the engine for approximately 5 to 60 minutes or drive the vehicle until stop and start control is permitted. Refer to PRECAUTION [11/2023 - ] Lane Control System Perform steering sensor zero point calibration Refer to INITIALIZATION [12/2019 - ] Pre-collision System Lighting System (EXT) (w/ AFS) - LEARNING COMPLETES WHEN VEHICLE IS OPERATED NORMALLY
Effect/Inoperative Function when Necessary Procedure not Performed Necessary Procedure Link Power Door Lock Control System Initialize back door lock Refer to INITIALIZATION [11/2023 - ] Power Back Door System Reset back door close position Refer to INITIALIZATION [11/2023 - ] Air Conditioning System After the ignition switch is turned to ON, the servo motor standard position is recognized. -