Operation Check [12/2019 - ]

HINT: 

• It is only necessary to perform an inspection when there are dents or distortion in the back door panel sub-assembly as a result of an accident.
• Inspections are not required when replacing parts or removing and reinstalling.

1. CAMERA IMAGE RANGE CONFIRMATION PROCEDURE 
   1. Set the vehicle in the position shown in the illustration and create a target on the wall.
      NOTE:

      • Perform this inspection on a level surface.
      • Remove all luggage from the vehicle before starting work.
      • Adjust the tire pressures to the specified pressure before starting work.

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      *a	Vehicle Center	*b	Wall, etc.
      *c	Target	*d	Vehicle Rear End
      *e	100 cm (3.28 ft.)	*f	106.2 cm (3.48 ft.)
      *g	36.1 cm (1.18 ft.)	*h	1.8 cm (0.7087 in.)

   2. Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      *1	Inner Rear View Mirror Assembly
      *a	Target
      *b	Mode Selection Lever

      With the ignition switch ON, set the mode selection lever to the digital mirror mode side and check that the target is displayed as shown in the illustration.

      HINT: 

      • Make sure the system is set to the default settings (position, zoom, etc.).
      • If the target is as shown in the illustration, the system is working correctly.