DSD Information System
Home >> Toyota >> 2021 >> Highlander LE, 4WD >> Repair and Diagnosis >> Accessories & Equipment >> Interior/Exterior Trim >> Exterior Panels / Trim - Service Information (1 Of 2) >> FRONT BUMPER (except Sport Package) >> Removal [11/2023 - ] >> Procedure

Removal [11/2023 - ]: Procedure

  1. REMOVE COOL AIR INTAKE DUCT SEAL 
    1. Remove the 9 clips and cool air intake duct seal.
      GTY896874Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. DISCONNECT FRONT FENDER WHEEL OPENING MOULDING SUB-ASSEMBLY LH 
    1. Apply protective tape around the front fender wheel opening moulding sub-assembly LH.
      GTY911856Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      Protective Tape
    2. Remove the 3 clips.
      GTY896875Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Remove the screw.
      GTY939100Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    4. Pull back the edge of the front fender liner LH and disengage the 4 claws by pushing the area indicated by the arrow in the illustration with a finger.
      GTY919065Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *1 Front Fender Liner LH
      Remove in this Direction
      NOTE:
      • Do not apply excessive force when pulling back the front fender liner LH.
      • To avoid damaging the claws, do not forcibly pull the front fender wheel opening moulding sub-assembly LH.
    5. Disengage the 2 clips and disconnect the front fender wheel opening moulding sub-assembly LH.
    6. Remove the 2 clips from the front fender wheel opening moulding sub-assembly LH.
  3. DISCONNECT FRONT FENDER WHEEL OPENING MOULDING SUB-ASSEMBLY RH 

    HINT: 

    Use the same procedure as for the LH side.

  4. REMOVE FRONT BUMPER ASSEMBLY 
    1. Apply protective tape around the front bumper assembly.
      GTY866085Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      Protective Tape

      HINT: 

      Use the same procedure for the RH side and LH side.

    2. Remove the 10 screws.
      GTY896848Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Remove the 4 bolts.
      GTY939094Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    4. Disengage the 6 claws.
      GTY896851Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      HINT: 

      Use the same procedure for the RH side and LH side.

    5. Disengage the claw to remove the front bumper assembly.
      GTY896849Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    6. Disconnect each connector.
      GTY935869Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *A w/ Fog Light

      HINT: 

      Use the same procedure for the LH side and RH side.

Diesel-Data.com