Caution / Notice / Hint

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during rear combination light assembly removal/installation are shown below.

HINT: 

• When the cable is disconnected / reconnected to the auxiliary battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.
  LEARNING COMPLETES WHEN VEHICLE IS DRIVEN
  
  

  Effect/Inoperative Function When Necessary Procedures are not Performed	Necessary Procedures	Link
  Stop and Start System	Idle the engine for approximately 5 to 60 minutes or drive the vehicle until stop and start control is permitted	Refer to PRECAUTION [11/2023 - ]
  Lane Control System	Perform steering sensor zero point calibration	Refer to INITIALIZATION [12/2019 - ]
  Pre-collision System
  Lighting System (EXT) (w/ AFS)

  LEARNING COMPLETES WHEN VEHICLE IS OPERATED NORMALLY
  
  

  Effect/Inoperative Function When Necessary Procedures are not Performed	Necessary Procedures	Link
  Power Door Lock Control System	Initialize back door lock	Refer to INITIALIZATION [11/2023 - ]
  Power Back Door System	Reset back door close position	Refer to INITIALIZATION [11/2023 - ]
  Air Conditioning System	After the ignition switch is turned to ON, the servo motor standard position is recognized.	-

• Use the same procedure for the RH side and LH side.
• The following procedure is for the LH side.