Caution / Notice / Hint
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during steering wheel switch housing removal/installation are shown below.
| Replaced Part or Performed Procedure | Necessary Procedure | Effect/Inoperative Function when Necessary Procedure not Performed | Link |
|---|---|---|---|
| Disconnect cable from negative auxiliary battery terminal | Perform steering sensor zero point calibration | Lane Control System | Refer to INITIALIZATION [12/2019 - ] |
| Parking Support Brake System*1 | |||
| Pre-collision System | |||
| Lighting System (EXT) (w/ AFS) | |||
| Memorize steering angle neutral point | Parking Assist Monitor System | Refer to INITIALIZATION [12/2019 - 10/2022] | |
| Panoramic View Monitor System | Refer to INITIALIZATION [12/2019 - 10/2022] | ||
| Initialize back door lock | Power Door Lock Control System | Refer to INITIALIZATION [12/2019 - 11/2023] | |
| Reset back door close position | Power Back Door System | Refer to INITIALIZATION [12/2019 - 11/2023] | |
| Removal/installation of the spiral cable with sensor sub-assembly | Steering angle setting | Parking Assist Monitor System | Refer to CALIBRATION [12/2019 - 10/2022] |
| Adjust steering angle | Panoramic View Monitor System | Refer to CALIBRATION [12/2019 - 10/2022] | |
| Steering angle neutral point | Parking Assist Monitor System | Refer to INITIALIZATION [12/2019 - 10/2022] | |
| Parking Support Brake System | Refer to CALIBRATION [12/2019 - 11/2023] | ||
| Panoramic View Monitor System | Refer to INITIALIZATION [12/2019 - 10/2022] |
*1: Learning can also be performed using the GTS.
Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.
Refer to PRECAUTION [12/2019 - 11/2023]
After the ignition switch is turned off, the radio and display receiver assembly or the radio receiver assembly records various types of memory and settings. As a result, after turning the ignition switch off, make sure to wait at least 120 seconds before disconnecting the cable from the negative (-) auxiliary battery terminal.
| Replaced Part or Performed Procedure | Necessary Procedure | Effect/Inoperative Function when Necessary Procedure not Performed | Link |
|---|---|---|---|
| Disconnect cable from negative auxiliary battery terminal | Idle the engine for approximately 5 to 60 minutes or drive the vehicle until stop and start control is permitted | Stop and Start System | Refer to PRECAUTION [12/2019 - 10/2022] |
| Perform steering sensor zero point calibration | Lane Control System | Refer to INITIALIZATION [12/2019 - ] | |
| Parking Support Brake System*1 | |||
| Pre-collision System | |||
| Lighting System (EXT) (w/ AFS) | |||
| Memorize steering angle neutral point | Parking Assist Monitor System | Refer to INITIALIZATION [12/2019 - 10/2022] | |
| Panoramic View Monitor System | Refer to INITIALIZATION [12/2019 - 10/2022] | ||
| Initialize back door lock | Power Door Lock Control System | Refer to INITIALIZATION [12/2019 - 11/2023] | |
| Reset back door close position | Power Back Door System | Refer to INITIALIZATION [12/2019 - 11/2023] | |
| Removal/installation of the spiral cable with sensor sub-assembly | Steering angle setting | Parking Assist Monitor System | Refer to CALIBRATION [12/2019 - 10/2022] |
| Adjust steering angle | Panoramic View Monitor System | Refer to CALIBRATION [12/2019 - 10/2022] | |
| Steering angle neutral point | Parking Assist Monitor System | Refer to INITIALIZATION [12/2019 - 10/2022] | |
| Parking Support Brake System | Refer to CALIBRATION [12/2019 - 11/2023] | ||
| Panoramic View Monitor System | Refer to INITIALIZATION [12/2019 - 10/2022] |
*1: Learning can also be performed using the GTS.
Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.
Refer to PRECAUTION [12/2019 - 11/2023]
After the ignition switch is turned off, the radio and display receiver assembly or the radio receiver assembly records various types of memory and settings. As a result, after turning the ignition switch off, make sure to wait at least 120 seconds before disconnecting the cable from the negative (-) auxiliary battery terminal.