Television Display Power Source Circuit [12/2019 - 10/2022]: Procedure

1. Disconnect the R16 television display assembly connector.
2. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   R16-17 (GND) - Body ground	Always	Below 1 Ω

3. Measure the voltage according to the value(s) in the table below.

   Standard Voltage

   Tester Connection	Condition	Specified Condition
   R16-1 (+B) - R16-17 (GND)	Always*1 Ignition switch off*2	11 to 14 V*3 10.5 to 16 V*4
   R16-2 (ACC) - R16-17 (GND)	Ignition switch ACC	11 to 14 V*3 10.5 to 16 V*4

   *1: for Gasoline Model

   *2: for HV Model

   *3: w/o Stop and Start System

   *4: w/ Stop and Start System

   Result

   Result	Proceed to
   OK	A
   NG (w/o Stop and Start System)	B
   NG (w/ Stop and Start System)	C

Result: 

A 

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE. Refer to  PROBLEM SYMPTOMS TABLE [12/2019 - 10/2022] 

Result: 

B 

REPAIR OR REPLACE HARNESS OR CONNECTOR 

Result: 

C 

GO TO STOP AND START SYSTEM. Refer to  HOW TO PROCEED WITH TROUBLESHOOTING [12/2019 - 10/2022]