DTC B2205: Kick Sensor Circuit [12/2019 - 11/2023]: Procedure

1. Clear the DTCs.

   Body Electrical > Back Door > Clear DTCs 

2. Recheck for DTCs.

   Body Electrical > Back Door > Trouble Codes 

   OK

   DTC B2205 is not output.

   Result

   Proceed to
   OK
   NG

Result: 

OK 

USE SIMULATION METHOD TO CHECK. Refer to  HOW TO PROCEED WITH TROUBLESHOOTING [12/2019 - ] 

Result: 

NG 

See step  2

1. Disconnect the V7*1 or V8*2 kick door control sensor connector.
   1. *1: w/o Towing Hitch
   2. *2: w/ Towing Hitch
2. Wait for approximately 60 seconds.
3. Clear the DTCs.

   Body Electrical > Back Door > Clear DTCs 

4. Check for DTCs.

   Body Electrical > Back Door > Trouble Codes 

   OK

   DTC B2205 is not output.

   Result

   Proceed to
   OK
   NG

Result: 

OK 

REPLACE KICK DOOR CONTROL SENSOR. Refer to  REMOVAL [12/2019 - 10/2022]  , or refer to  REMOVAL [10/2022 - 11/2023] 

Result: 

NG 

See step  3

1. Disconnect the W18 multiplex network door ECU connector.
2. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   W/O TOWING HITCH
   
   

   Tester Connection	Condition	Specified Condition
   W18-14 (KSIN) or V7-3 (KSOT) - Body ground	Always	10 kΩ or higher

   W/ TOWING HITCH
   
   

   Tester Connection	Condition	Specified Condition
   W18-14 (KSIN) or V8-3 (KSOT) - Body ground	Always	10 kΩ or higher

   Result

   Proceed to
   OK
   NG

Result: 

OK 

REPLACE MULTIPLEX NETWORK DOOR ECU. Refer to  REMOVAL [12/2019 - 11/2023] 

Result: 

NG 

REPAIR OR REPLACE HARNESS OR CONNECTOR