Power Back Door does not Operate Using Outside Switch [12/2019 - 11/2023]: Procedure

1. Read the Data List according to the display on the GTS.

   Body Electrical > Back Door > Data List 

   Tester Display	Measurement Item	Range	Normal Condition	Diagnostic Note
   PBD Close SW	No. 1 power back door control switch	OFF or ON	OFF: No. 1 power back door control switch not pressed ON: No. 1 power back door control switch pressed	-

   Body Electrical > Back Door > Data List 

   Tester Display
   PBD Close SW

   OK

   The display is as specified in the normal condition column.

   Result

   Proceed to
   OK
   NG

Result: 

OK 

REPLACE MULTIPLEX NETWORK DOOR ECU. Refer to  REMOVAL [12/2019 - 11/2023] 

Result: 

NG 

See step  2

Refer to INSPECTION [12/2019 - ]

Result

Result: 

NG 

REPLACE NO. 1 POWER BACK DOOR CONTROL SWITCH. Refer to  REMOVAL [12/2019 - ] 

Result: 

OK 

See step  3

1. Disconnect the W18 multiplex network door ECU connector.
2. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   W17-5 (CLS) - W18-8 (BDDN)	Always	Below 1 Ω
   W17-2 (E) - Body ground	Always	Below 1 Ω
   W17-5 (CLS) or W18-8 (BDDN) - Body ground	Always	10 kΩ or higher

   Result

   Proceed to
   OK
   NG

Result: 

OK 

REPLACE MULTIPLEX NETWORK DOOR ECU. Refer to  REMOVAL [12/2019 - 11/2023] 

Result: 

NG 

REPAIR OR REPLACE HARNESS OR CONNECTOR