Freeze Frame Data [12/2019 - 11/2023]
- FREEZE FRAME DATA
- Whenever a DTC is detected, the multiplex network door ECU stores the current vehicle state as Freeze Frame Data.
- CHECK FREEZE FRAME DATA
- Connect the GTS to the DLC3.
- Turn the ignition switch to ON.
- Turn the GTS on.
- Enter the following menus: Body Electrical / Back Door / Trouble Codes.
Body Electrical > Back Door
Tester Display Measurement Item Range Normal Condition Diagnostic Note Half Latch SW Half-latch switch signal OFF or ON OFF: Back door lock motor in full latch or half latch position
ON: Back door lock motor in open latch position- Closer Position SW Position switch signal OFF or ON OFF: Back door lock center gear out of center position (Position switch off)
ON: Back door lock center gear in center position (Position switch on)- Pawl Position Switch Pawl position switch signal OFF or ON OFF: Back door lock motor except open latched
ON: Back door lock motor open latched- Courtesy SW Back door courtesy switch signal OFF or ON OFF: Back door closed
ON: Back door open- Back Door Position Status of the back door position -4000 to 21500 Edge 3000 to 6000 Edge - Back Door Horizontal Torsion Status of the torsion between back door LH and RH -128 to 127 Edge -128 to 127 Edge - Battery Voltage Status of the auxiliary battery voltage 0 to 31 V 11 to 14 V - Closer Control Status Status of the closer control Initialize, Close 1: Standby, Close 2: Operate Standby, Close 3: Operation, Close 4: Return Standby, Close 5: Return, Release 1: Standby, Release 2: Operation, Release 3: Return Standby, Release 4: Return, Forcible 1: Release Operation, Forcible 2: Close Standby, Forcible 3: Close Operation Standby, Forcible 4: Close Operation, Forcible 5: Closer Torque Moderate, Forcible 6: Door Check or Stop Function Status of the closer control - PBD Control Status Status of the power back door system control All Close Initialize, All Close, Open 1: Auto Open Standby, Open 2: Latch Release Standby, Open 3: Auto Open Operation, All Open, Close 1: Auto Close Standby, Close 2: Auto Close Operation, Close 3: Closer Start Standby, Close 4: All Close Standby, Neutral, Auto Close Reverse or Brake Status of the power back door system control - #Codes Number of DTCs Min.: 0, Max.: 255 Number of DTCs will be displayed -
- CLEAR FREEZE FRAME DATA NOTE:
Clearing the DTCs will also clear the Freeze Frame Data.
- Connect the GTS to the DLC3.
- Turn the ignition switch to ON.
- Turn the GTS on.
- Clear the DTCs and Freeze Frame Data.