Installation [12/2019 - 10/2022]: Procedure

1. Temporarily install the transmission floor shift assembly to the shift and select lever support with the 4 bolts.
2. Tighten the 4 bolts in the order shown in the illustration.
   Fig 1: Transmission Floor Shift Assembly Bolts Tightening Sequence

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   Torque: 12 N.m (122 kgf/cm, 9 ft.lbf) 

3. Engage the 2 clamps to connect the wire harness to the transmission floor shift assembly.
4. Connect the shift lock control ECU connector.
5. Connect the transmission control switch connector.

1. Slide the slider of the transmission control cable assembly in the direction indicated by the arrow in the illustration and pull the lock piece outward.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *a	Slider
   *b	Lock Piece
   *c	Slide
   *d	Pull

2. Turn the lock nut of the transmission control cable assembly counterclockwise. While holding the lock nut, push in the stopper.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *a	Lock Nut
   *b	Push in
   *c	Stopper

   NOTE:

   Do not turn the lock nut of the transmission control cable assembly excessively as the internal spring may come off and the transmission control cable assembly will not be reusable.

3. Connect the transmission control cable assembly to the transmission floor shift assembly.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *a

   Stopper

   NOTE:

   • Install the transmission control cable assembly with the stopper facing upwards.
   • After installation, check that the outer part of the stopper is as shown in the illustration.
   • Make sure that the transmission control cable assembly is securely locked.
4. Connect the transmission control cable assembly to the transmission floor shift assembly.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *a	Lock Piece
   *b	Adjuster Case

   NOTE:

   • Check that the lock piece is pulled out.
   • Push the end of the transmission control cable assembly all the way to the base of the transmission floor shift assembly pin.
   • Connect the transmission control cable assembly so that the lock piece faces the driver side.
5. Push the lock piece into the adjuster case.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *a	Lock Piece
   *b	Push in
   *c	Adjuster Case

   NOTE:

   • Check that the shift lever is in N.
   • Securely push in the lock piece until the slider lock is engaged.
   • When pushing in the lock piece of the adjuster case to lock it, remove your hand from the lever shaft.

     Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

     *1	Transmission Control Cable Assembly
     *a	Lever Shaft

   • When pushing in the lock piece of the adjuster case to lock it, do not move the lever shaft or transmission control cable assembly forward or backward.
6. After adjusting the shift lever position, check the position and operation of the shift lever. If there is a problem, adjust the shift lever position again.

Refer to PROCEDURE - Step 4

Refer to PROCEDURE - Step 29

Refer to PROCEDURE - Step 26

Refer to INSTALLATION [12/2019 - 10/2022]

1. Engage the 2 claws to install the shift lock release button cover to the shift position indicator.

See step  2