Installation [12/2019 - 09/2020]: Procedure

INSTALL HOOD LOCK CONTROL CABLE ASSEMBLY
1. Pass the hood lock control cable assembly into the engine compartment.
2. Engage the grommet.
3. Engage each clamp to install the hood lock control cable assembly.
INSTALL HOOD LOCK CONTROL LEVER SUB-ASSEMBLY
1. Connect the hood lock control cable assembly to install the hood lock control lever sub-assembly.
INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
Refer to PROCEDURE - Step 29
INSTALL COWL SIDE TRIM SUB-ASSEMBLY LH
Refer to PROCEDURE - Step 51
INSTALL FRONT DOOR SCUFF PLATE LH
Refer to PROCEDURE - Step 52
INSTALL HOOD LOCK ASSEMBLY
1. Apply MP grease to the sliding areas of the hood lock assembly.
2. Connect the hood lock control cable assembly to the hood lock assembly.
3. Install the hood lock assembly with the 2 bolts and hood lock bolt.
  Torque: 8.0 N.m (82 kgf/cm, 71 in.lbf)
  
  HINT:
  
  The hood lock nut cap is a non-reusable part. Be sure to install it after inspecting and adjusting the hood sub-assembly.
4. w/ Engine Hood Courtesy Switch:
  1. Connect the connector.
  2. Engage the clamp.
INSTALL COOL AIR INTAKE DUCT SEAL
Refer to PROCEDURE - Step 4
INSTALL FRONT FENDER LINER LH
Refer to PROCEDURE - Step 2
INSTALL FRONT WHEEL OPENING EXTENSION PAD LH
Refer to PROCEDURE - Step 3
INSTALL FRONT FENDER WHEEL OPENING MOULDING SUB-ASSEMBLY LH
Refer to PROCEDURE - Step 3
INSTALL FRONT FENDER MUDGUARD LH (w/ Mudguard)
Refer to PROCEDURE - Step 2
INSTALL FRONT WHEEL LH
Refer to INSTALLATION [12/2019 - 10/2022]
ADJUST HOOD SUB-ASSEMBLY
Refer to ADJUSTMENT [12/2019 - 09/2020]