DSD Information System
Home >> Toyota >> 2021 >> Highlander LE, 4WD >> Repair and Diagnosis >> Drivelines & Axles >> Differentials & Drive Axles >> Axle And Differential - Service Information (1 Of 2) >> REAR AXLE HUB (for 2WD) >> Removal [11/2023 - ] >> Procedure

Removal [11/2023 - ]: Procedure

  1. DISABLE BRAKE CONTROL (for HV Model) 

    Refer to PROCEDURE - Step 4

  2. REMOVE REAR WHEEL 

    Refer to PROCEDURE - Step 1

  3. REMOVE REAR SUSPENSION ARM COVER 

    Refer to PROCEDURE - Step 3

  4. DISCONNECT NO. 2 PARKING BRAKE WIRE ASSEMBLY 
    1. Disconnect the No. 2 parking brake wire assembly connector from the parking brake actuator assembly.
      NOTE:
      • Remove any dirt or foreign matter on and around the No. 2 parking brake wire assembly connector before performing this step.
      • Do not allow water, oil or dirt to enter the No. 2 parking brake wire assembly connector.
      GTY917921Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Using a screwdriver with its tip wrapped with protective tape, disconnect the No. 2 parking brake wire assembly connector from the rear axle hub and bearing assembly.
      GTY845095Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Protective Tape
      NOTE:
      • Remove any dirt or foreign matter on and around the No. 2 parking brake wire assembly connector before performing this step.
      • Do not allow water, oil or dirt to enter the No. 2 parking brake wire assembly connector.
      • Be careful not to damage the rear axle hub and bearing assembly or connector cover.
  5. SEPARATE REAR DISC BRAKE CYLINDER ASSEMBLY 

    See step  4

  6. REMOVE REAR DISC BRAKE CYLINDER MOUNTING WITH BRAKE PAD 

    See step  5

  7. REMOVE REAR DISC 

    Refer to PROCEDURE - Step 16

  8. REMOVE REAR AXLE HUB AND BEARING ASSEMBLY 
    1. Remove the 4 bolts, rear axle hub and bearing assembly and rear disc brake dust cover sub-assembly from the rear axle carrier sub-assembly.
      GTY911652Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
Diesel-Data.com