DSD Information System
Home >> Toyota >> 2021 >> Highlander LE, 4WD >> Repair and Diagnosis >> Body & Frame >> Windows >> Window / Glass - Service Information >> POWER WINDOW REGULATOR MOTOR (for Rear Door) >> Installation [10/2022 - ] >> Procedure

Installation [10/2022 - ]: Procedure

  1. INSTALL POWER WINDOW REGULATOR MOTOR ASSEMBLY 
    NOTE:

    The regulator arm must be below the intermediate position when installing the power window regulator motor assembly.

    1. Using a T25 "TORX" socket wrench, install the power window regulator motor assembly with the 3 screws.

      Torque: 5.4 N.m (55 kgf/cm, 48 in.lbf) 

      HINT: 

      When replacing a power window regulator motor assembly, a new power window regulator motor assembly uses self-tapping screws to thread new installation holes when the self-tapping screws are inserted.

  2. INSTALL REAR DOOR WINDOW REGULATOR ASSEMBLY 

    Refer to PROCEDURE - Step 22

  3. INSTALL REAR DOOR GLASS SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 23

  4. INSTALL REAR DOOR WINDOW DIVISION BAR SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 26

  5. INSTALL REAR DOOR GLASS RUN 

    Refer to PROCEDURE - Step 27

  6. INSTALL REAR DOOR SERVICE HOLE COVER 

    Refer to PROCEDURE - Step 28

  7. INSTALL QUARTER WINDOW UPPER STOP 

    Refer to PROCEDURE - Step 29

  8. INSTALL REAR DOOR INNER GLASS WEATHERSTRIP 

    Refer to PROCEDURE - Step 31

  9. CONNECT REAR DOOR WEATHERSTRIP 
    1. Connect the rear door weatherstrip.
  10. INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 41

  11. INSTALL REAR DOOR INSIDE HANDLE BEZEL 

    Refer to PROCEDURE - Step 42

  12. INSTALL REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR UPPER ARMREST BASE PANEL 

    Refer to PROCEDURE - Step 43

  13. CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL 

    for T24A-FTS:

    Refer to PROCEDURE - Step 4 [10/2022 - 11/2023] , or refer to PROCEDURE - Step 4 [11/2023 - ]

    for A25A-FXS:

    Refer to PROCEDURE - Step 2 [12/2019 - 11/2023] , or refer to PROCEDURE - Step 2 [11/2023 - ]

  14. INSTALL BATTERY SERVICE HOLE COVER (for HV Model) 

    Refer to PROCEDURE - Step 3 [12/2019 - 11/2023] , or refer to PROCEDURE - Step 3 [11/2023 - ]

  15. INITIALIZE POWER WINDOW CONTROL SYSTEM 

    Refer to INITIALIZATION [12/2019 - ]

  16. INSPECT POWER WINDOW OPERATION 

    Refer to OPERATION CHECK [12/2019 - ]

Diesel-Data.com