DSD Information System
Home >> Toyota >> 2021 >> Highlander LE, 4WD >> Repair and Diagnosis >> Electrical >> Starter >> Starting System (W/ Stop And Start System) (2GR-FKS) - Service Information >> STARTER (w/ Stop And Start System) >> Installation [12/2019 - 09/2020] >> Procedure

Installation [12/2019 - 09/2020]: Procedure

  1. INSTALL STARTER ASSEMBLY 
    1. Install the wire harness clamp to the starter assembly.
    2. Type A:
      1. Install the starter assembly with the 2 bolts.

        Torque: 37 N.m (377 kgf/cm, 27 ft.lbf) 

    3. Type B:
      1. Using an E8 "TORX" socket wrench, temporarily install the starter assembly with the 2 stud bolts.

        Torque: 37 N.m (377 kgf/cm, 27 ft.lbf) 

      2. Install the starter assembly with the 2 nuts.

        Torque: 37 N.m (377 kgf/cm, 27 ft.lbf) 

    4. Connect terminal 30 with the nut.

      Torque: 9.8 N.m (100 kgf/cm, 87 in.lbf) 

    5. Close the terminal cap.
    6. Engage the wire harness clamp.
    7. Connect the 2 starter assembly connectors.
  2. INSTALL BATTERY CLAMP SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 45

  3. INSTALL ECM 

    Refer to PROCEDURE - Step 3

  4. INSTALL AIR CLEANER ASSEMBLY WITH AIR CLEANER HOSE 

    Refer to PROCEDURE - Step 50

  5. INSTALL INLET AIR CLEANER ASSEMBLY 

    Refer to PROCEDURE - Step 51

  6. INSTALL COOL AIR INTAKE DUCT SEAL 

    Refer to PROCEDURE - Step 4

  7. INSTALL BATTERY 

    Refer to INSTALLATION [12/2019 - 10/2022]

Diesel-Data.com