Removal [10/2022 - 11/2023]: Procedure
- PRECAUTION NOTE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.
- REMOVE BATTERY SERVICE HOLE COVER (for HV Model)
Refer to PROCEDURE - Step 1
- DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL
for T24A-FTS:
Refer to PROCEDURE - Step 1
for A25A-FXS:
Refer to PROCEDURE - Step 2
- REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH
Refer to PROCEDURE - Step 4
- REMOVE MULTIPLEX NETWORK MASTER SWITCH ASSEMBLY WITH FRONT DOOR UPPER ARMREST BASE PANEL (for Driver Side)
Refer to PROCEDURE - Step 5
- REMOVE POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT DOOR UPPER ARMREST BASE PANEL (for Front Passenger Side)
Refer to PROCEDURE - Step 6
- REMOVE FRONT DOOR INSIDE HANDLE BEZEL
Refer to PROCEDURE - Step 7
- REMOVE COURTESY LIGHT ASSEMBLY
Refer to PROCEDURE - Step 1
- REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY
Refer to PROCEDURE - Step 9
- REMOVE FRONT DOOR INNER GLASS WEATHERSTRIP
Refer to PROCEDURE - Step 17
- REMOVE FRONT DOOR WEATHERSTRIP CLIP
Refer to PROCEDURE - Step 21
- REMOVE FRONT DOOR SERVICE HOLE COVER
Refer to PROCEDURE - Step 22
- REMOVE FRONT DOOR GLASS SUB-ASSEMBLY
Refer to PROCEDURE - Step 24
- REMOVE FRONT DOOR BELT MOULDING ASSEMBLY
