Installation [12/2019 - 10/2022]: Procedure
- INSTALL POWER WINDOW REGULATOR MOTOR ASSEMBLY NOTE:
The regulator arm must be below the intermediate position when installing the power window regulator motor assembly.
- Using a T25 "TORX" socket wrench, install the power window regulator motor assembly with the 3 screws.
Torque: 5.4 N.m (55 kgf/cm, 48 in.lbf)
HINT:
When replacing a power window regulator motor assembly, a new power window regulator motor assembly uses self-tapping screws to thread new installation holes when the self-tapping screws are inserted.
- Using a T25 "TORX" socket wrench, install the power window regulator motor assembly with the 3 screws.
- INSTALL REAR DOOR WINDOW REGULATOR ASSEMBLY
Refer to PROCEDURE - Step 22
- INSTALL REAR DOOR GLASS SUB-ASSEMBLY
Refer to PROCEDURE - Step 23
- INSTALL REAR DOOR WINDOW DIVISION BAR SUB-ASSEMBLY
Refer to PROCEDURE - Step 26
- INSTALL REAR DOOR GLASS RUN
Refer to PROCEDURE - Step 27
- INSTALL REAR DOOR SERVICE HOLE COVER
Refer to PROCEDURE - Step 28
- INSTALL QUARTER WINDOW UPPER STOP
Refer to PROCEDURE - Step 29
- INSTALL REAR DOOR INNER GLASS WEATHERSTRIP
Refer to PROCEDURE - Step 31
- CONNECT REAR DOOR WEATHERSTRIP
- Connect the rear door weatherstrip.
- INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY
Refer to PROCEDURE - Step 41
- INSTALL REAR DOOR INSIDE HANDLE BEZEL
Refer to PROCEDURE - Step 42
- INSTALL REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR UPPER ARMREST BASE PANEL
Refer to PROCEDURE - Step 43
- CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL
for 2GR-FKS: Refer to PROCEDURE - Step 2
for A25A-FXS: Refer to PROCEDURE - Step 2
- INSTALL BATTERY SERVICE HOLE COVER (for HV Model)
Refer to PROCEDURE - Step 3
- INITIALIZE POWER WINDOW CONTROL SYSTEM
Refer to INITIALIZATION [12/2019 - ]
- INSPECT POWER WINDOW OPERATION
Refer to OPERATION CHECK [12/2019 - ]