Disassembly [12/2019 - 10/2022]: Procedure
- REMOVE OUTER MIRROR
See step 1
- REMOVE OUTER MIRROR COVER
See step 2
- REMOVE VISOR HOUSING
- REMOVE LOWER HOUSING
- w/ Panoramic View Monitor System:
- Disengage the 2 claws.
- Insert a 0.9 mm (0.0354 in.) spark plug gap gauge or similar tool into the connector as shown in the illustration.
*a Claw *b Protrusion *c Insert Position NOTE:- Insert the spark plug gap gauge to the point that the claw becomes the same height as the protrusion of the connector housing. If the spark plug gap gauge is inserted too far, or if the claw is lifted directly using a screwdriver, the claw may be damaged.
- If the claw of the connector is damaged, replace the outer rear view mirror assembly.
- Lift the claw and disconnect the connector.
- Disengage the 2 claws.
- Disengage the 3 claws.
- Disengage the claw and 2 guides as shown in the illustration to remove the lower housing.

Remove in this Direction
- w/ Panoramic View Monitor System:
- REMOVE SIDE TURN SIGNAL LIGHT ASSEMBLY
Refer to PROCEDURE - Step 5
- REMOVE OUTER MIRROR ACTUATOR ASSEMBLY
- REMOVE SIDE TELEVISION CAMERA ASSEMBLY (w/ Panoramic View Monitor System)
Refer to PROCEDURE - Step 5
- REMOVE OUTER MIRROR LIGHT ASSEMBLY (w/ Foot light)
Refer to PROCEDURE - Step 5
- REMOVE OUTER MIRROR BOTTOM COVER (w/ Wire Harness)








