Installation [12/2019 - 10/2022]: Procedure

INSTALL REAR DOOR BELT MOULDING ASSEMBLY

Engage the 6 claws to install a new rear door belt moulding assembly as shown in the illustration.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Install in this Direction

INSTALL REAR DOOR GLASS SUB-ASSEMBLY
Refer to PROCEDURE - Step 23
INSTALL REAR DOOR QUARTER WINDOW GLASS
Refer to PROCEDURE - Step 25
INSTALL REAR DOOR WINDOW DIVISION BAR SUB-ASSEMBLY
Refer to PROCEDURE - Step 26
CONNECT REAR DOOR WEATHERSTRIP
Refer to PROCEDURE - Step 9
INSTALL REAR DOOR GLASS RUN
Refer to PROCEDURE - Step 27
INSTALL REAR DOOR SERVICE HOLE COVER
Refer to PROCEDURE - Step 28
INSTALL QUARTER WINDOW UPPER STOP
Refer to PROCEDURE - Step 29
INSTALL REAR DOOR INNER GLASS WEATHERSTRIP
Refer to PROCEDURE - Step 31
INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY
Refer to PROCEDURE - Step 41
INSTALL REAR DOOR INSIDE HANDLE BEZEL
Refer to PROCEDURE - Step 42
INSTALL REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR UPPER ARMREST BASE PANEL
Refer to PROCEDURE - Step 43
CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL
for 2GR-FKS:

Refer to PROCEDURE - Step 2

for A25A-FXS:

Refer to PROCEDURE - Step 2
INSTALL BATTERY SERVICE HOLE COVER (for HV Model)
Refer to PROCEDURE - Step 3
INITIALIZE POWER WINDOW CONTROL SYSTEM
Refer to INITIALIZATION [12/2019 - ]
INSPECT POWER WINDOW OPERATION
Refer to OPERATION CHECK [12/2019 - ]