Removal [11/2023 - ]: Procedure
- REMOVE DECK BOARD ASSEMBLY
Refer to PROCEDURE - Step 1
- REMOVE NO. 3 DECK BOARD SUB-ASSEMBLY (w/o Woofer)
Refer to PROCEDURE - Step 2
- REMOVE TONNEAU COVER ASSEMBLY (w/ Tonneau Cover)
Refer to PROCEDURE - Step 3
- REMOVE BATTERY SERVICE HOLE COVER
Refer to PROCEDURE - Step 4
- REMOVE REAR DECK FLOOR BOX
Refer to PROCEDURE - Step 5
- REMOVE DECK SIDE TRIM BOX LH (w/o Woofer)
Refer to PROCEDURE - Step 6
- REMOVE REAR FLOOR FINISH PLATE
Refer to PROCEDURE - Step 7
- REMOVE REAR NO. 2 SEAT ASSEMBLY
Refer to REMOVAL [12/2019 - ]
- REMOVE REAR OUTER SEAT TRACK BRACKET COVER LH
Refer to PROCEDURE - Step 13
- REMOVE REAR DOOR SCUFF PLATE LH
Refer to PROCEDURE - Step 14
- DISCONNECT REAR DOOR OPENING TRIM WEATHERSTRIP LH
- Disconnect the rear door opening trim weatherstrip LH.
- REMOVE FRONT DECK SIDE TRIM COVER LH
Refer to PROCEDURE - Step 31
- REMOVE NO. 2 DECK SIDE TRIM COVER
Refer to PROCEDURE - Step 33
- REMOVE DECK TRIM POCKET COVER
Refer to PROCEDURE - Step 35
- REMOVE NO. 1 LUGGAGE COMPARTMENT TRIM HOOK
Refer to PROCEDURE - Step 36
- REMOVE ROPE HOOK
Refer to PROCEDURE - Step 37
- REMOVE DECK TRIM SIDE PANEL ASSEMBLY LH
Refer to PROCEDURE - Step 38
- REMOVE ELECTRICAL KEY AND TIRE PRESSURE WARNING ECU AND RECEIVER NOTE:
- Do not drop, strike or otherwise subject the electrical key and tire pressure warning ECU and receiver to impact.
- If the electrical key and tire pressure warning ECU and receiver is subjected to an impact, replace it with a new one.
