Installation [11/2023 - ]: Procedure

INSTALL ELECTRICAL KEY AND TIRE PRESSURE WARNING ECU AND RECEIVER
NOTE:
- Do not drop, strike or otherwise subject the electrical key and tire pressure warning ECU and receiver to impact.
- If the electrical key and tire pressure warning ECU and receiver is subjected to an impact, replace it with a new one.
1. Connect the connector.
2. Engage the 2 guides and install the electrical key and tire pressure warning ECU and receiver with the bolt.
  Torque: 10 N.m (102 kgf/cm, 7 ft.lbf)
INSTALL DECK TRIM SIDE PANEL ASSEMBLY LH
Refer to PROCEDURE - Step 21
INSTALL ROPE HOOK
Refer to PROCEDURE - Step 22
INSTALL NO. 1 LUGGAGE COMPARTMENT TRIM HOOK
Refer to PROCEDURE - Step 23
INSTALL DECK TRIM POCKET COVER
Refer to PROCEDURE - Step 24
INSTALL NO. 2 DECK SIDE TRIM COVER
Refer to PROCEDURE - Step 26
INSTALL FRONT DECK SIDE TRIM COVER LH
Refer to PROCEDURE - Step 28
INSTALL REAR DOOR OPENING TRIM WEATHERSTRIP LH
Refer to PROCEDURE - Step 1
INSTALL REAR DOOR SCUFF PLATE LH
Refer to PROCEDURE - Step 45
INSTALL REAR OUTER SEAT TRACK BRACKET COVER LH
Refer to PROCEDURE - Step 46
INSTALL REAR NO. 2 SEAT ASSEMBLY
Refer to INSTALLATION [12/2019 - ]
INSTALL REAR FLOOR FINISH PLATE
Refer to PROCEDURE - Step 63
INSTALL DECK SIDE TRIM BOX LH (w/o Woofer)
Refer to PROCEDURE - Step 64
INSTALL REAR DECK FLOOR BOX
Refer to PROCEDURE - Step 65
INSTALL BATTERY SERVICE HOLE COVER
Refer to PROCEDURE - Step 66
INSTALL TONNEAU COVER ASSEMBLY (w/ Tonneau Cover)
Refer to PROCEDURE - Step 67
INSTALL NO. 3 DECK BOARD SUB-ASSEMBLY (w/o Woofer)
Refer to PROCEDURE - Step 68
INSTALL DECK BOARD ASSEMBLY
Refer to PROCEDURE - Step 69
PERFORM INITIALIZATION
Refer to INITIALIZATION [11/2023 - ]