DSD Information System
Home >> Toyota >> 2021 >> Highlander LE, 4WD >> Repair and Diagnosis >> Body & Frame >> Exterior Body Panels >> Door / Hatch - Service Information (1 Of 2) >> Hood Lock Control Cable Assembly >> Installation [09/2020 - ] >> Procedure

Installation [09/2020 - ]: Procedure

  1. INSTALL HOOD LOCK CONTROL CABLE ASSEMBLY 
    1. Pass the hood lock control cable assembly into the engine compartment.
    2. Engage the grommet.
    3. Engage each clamp to install the hood lock control cable assembly.
  2. INSTALL HOOD LOCK CONTROL LEVER SUB-ASSEMBLY 
    1. Connect the hood lock control cable assembly to install the hood lock control lever sub-assembly.
  3. INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 29 [12/2019 - 10/2022] , or refer to PROCEDURE - Step 28 [10/2022 - ]

  4. INSTALL COWL SIDE TRIM SUB-ASSEMBLY LH 

    Refer to PROCEDURE - Step 51 [12/2019 - 10/2022] , or refer to PROCEDURE - Step 49 [10/2022 - ]

  5. INSTALL FRONT DOOR SCUFF PLATE LH 

    Refer to PROCEDURE - Step 52 [12/2019 - 10/2022] , or refer to PROCEDURE - Step 50 [10/2022 - ]

  6. INSTALL HOOD LOCK ASSEMBLY 
    1. Apply MP grease to the sliding areas of the hood lock assembly.
    2. Connect the hood lock control cable assembly to the hood lock assembly.
    3. Install the hood lock assembly with the 2 bolts and hood lock bolt.

      Torque: 8.0 N.m (82 kgf/cm, 71 in.lbf) 

      HINT: 

      The hood lock nut cap is a non-reusable part. Be sure to install it after inspecting and adjusting the hood sub-assembly.

    4. w/ Engine Hood Courtesy Switch:
      1. Connect the connector.
      2. Engage the clamp.
  7. INSTALL COOL AIR INTAKE DUCT SEAL 

    for except Sport Package:

    Refer to PROCEDURE - Step 4

    for Sport Package:

    Refer to PROCEDURE - Step 4

  8. INSTALL FRONT FENDER LINER LH 

    Refer to PROCEDURE - Step 2

  9. INSTALL FRONT WHEEL OPENING EXTENSION PAD LH 

    Refer to PROCEDURE - Step 3

  10. INSTALL FRONT FENDER WHEEL OPENING MOULDING SUB-ASSEMBLY LH 

    Refer to PROCEDURE - Step 3

  11. INSTALL FRONT FENDER MUDGUARD LH (w/ Mudguard) 

    Refer to PROCEDURE - Step 2

  12. INSTALL FRONT WHEEL LH 

    Refer to INSTALLATION [12/2019 - 10/2022] , or refer to INSTALLATION [10/2022 - ]

  13. ADJUST HOOD SUB-ASSEMBLY 

    Refer to ADJUSTMENT [09/2020 - ] 

Diesel-Data.com