DSD Information System
Home >> Toyota >> 2021 >> Highlander LE, 4WD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 14 (Engine Cooling System (A25A-FXS) - Service Information) >> Thermostat >> Installation [12/2019 - 10/2021] >> Procedure

Installation [12/2019 - 10/2021]: Procedure

WARNING: This page is about a different variant/trim than selected.
  1. INSTALL WATER INLET WITH THERMOSTAT SUB-ASSEMBLY 
    1. Install a new gasket to the water inlet with thermostat sub-assembly.

      HINT: 

      Be sure to clean the contact surfaces.

    2. Using an 8 mm socket wrench, install the water inlet with thermostat sub-assembly with the 2 bolts.

      Torque: 10 N.m (102 kgf/cm, 7 ft.lbf) 

    3. Connect the No. 7 water by-pass hose to the water inlet with thermostat sub-assembly and slide the clip to secure it.
    4. Connect the water inlet with thermostat sub-assembly connector.
  2. CONNECT NO. 2 RADIATOR HOSE 

    Refer to PROCEDURE - Step 35

  3. ADD ENGINE COOLANT (for Engine) 

    Refer to PROCEDURE - Step 2

  4. INSPECT FOR COOLANT LEAK (for Engine) 

    Refer to PROCEDURE - Step 1

Diesel-Data.com