Installation [12/2019 - 10/2022]: Procedure

1. Apply adhesive to the area shown in the illustration.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *a	Oil Inlet Port
   *b	3 Threads or More
   	Adhesive Application Area

   Adhesive

   Toyota Genuine Adhesive 1344, Three Bond 1344 or equivalent

   NOTE:

   • Do not apply adhesive to the oil inlet port of the engine oil pressure switch assembly.
   • Apply the adhesive to the first 3 threads or more of the engine oil pressure switch assembly.
   • Apply adhesive to the entire circumference of the thread.
   • Install the engine oil pressure switch assembly within 3 minutes of applying adhesive.
2. Using a 24 mm deep socket wrench, install the engine oil pressure switch assembly.

   Torque: 15 N.m (153 kgf/cm, 11 ft.lbf) 

   NOTE:

   Do not start the engine for at least 1 hour after installation.

3. Connect the engine oil pressure switch assembly connector.
4. Engage the clamp to connect the wire harness protector.

Refer to PROCEDURE - Step 5 [12/2019 - 09/2020] , or refer to PROCEDURE - Step 5 [09/2020 - 10/2021] , or refer to PROCEDURE - Step 5 [10/2021 - 10/2022]

Refer to PROCEDURE - Step 1

Refer to PROCEDURE - Step 6 [12/2019 - 09/2020] , or refer to PROCEDURE - Step 6 [09/2020 - 10/2021] , or refer to PROCEDURE - Step 6 [10/2021 - 10/2022]

Refer to PROCEDURE - Step 75 [12/2019 - 09/2020] , or refer to PROCEDURE - Step 75 [09/2020 - 10/2022]